R Safety Hub R Safety Hub Your prescription for a safer workplace

Circular Saws — Guards and Triggers (Part 1 of 2)

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Today is about saws, starting with the circular saw. This is part one of two. Part two is table saws, miter saws and radial arm saws.

Everybody here has run one a thousand times. That is exactly why we talk about it. Nobody gets cut on the cut they are nervous about. They get cut on the one they have made a thousand times.

The guard stays on

The rule is plain. If a power tool is designed to take a guard, the guard is on it when you use it.

A circular saw has two guards. The upper guard covers the blade down to the depth of the teeth, except a small arc so the base can tilt for bevel cuts. The lower guard does the same under the base plate, except the small arc it needs to pull back and touch the work. And when you pull the saw out of the cut, the lower guard has to snap back over the blade, by itself, right away.

So, the big one. The rule wants the guard on and snapping back by itself, so never pin the lower guard back. Not with a wedge, not with a nail, not with a zip tie. If the guard is sticky or slow, the saw is not fit to use. Tag it and get it fixed.

Before you cut, unplug the saw or take the battery out, then push the lower guard open and let it go. It should snap shut. If it drags, it's done for the day.

And that blade is still spinning after you let go of the trigger. Wait for it to stop before you set the saw down.

The trigger and the blade

A hand-held circular saw has to have a switch you hold down. Let go, and the power shuts off. The rule requires that switch. Our plain reading: a rigged trigger means that saw is out of service.

Never run a saw faster than the maker's recommended speed. Check that the blade is rated for the speed of the saw it's going on. That check is good practice; the rule is the maker's speed.

And keep your tools in safe condition. That goes for the saw the company bought and the one you brought from home.

Protective gear

You use the eye protection and other gear the job calls for. A saw throws chips and dust, and sometimes a tooth. Where the dust is harmful, the gear covers that too.

Talk it over

  1. Pick up your saw today and test the lower guard. Does it snap shut?
  2. Is anybody's trigger or guard rigged, taped or pinned, and what do we do with that saw?

Before you go

The guard stays on. Let the guard snap back. Wait for the blade to stop.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-155-350(1) (tools in safe condition, employer or employee furnished), (2)(a) (guards on when designed for them), (3) (PPE), (4)(d) (circular saws: constant pressure switch that shuts off the power when pressure is released); 296-155-370(1) (not over the maker's recommended speed), (2) (portable circular saw guards above and below the base; lower guard returns automatically and instantly), (8) (PPE per Part C). Federal: 29 CFR 1926.304(d); 1926.300(b)(1) not read. Pointer, not quoted: WAC 296-155-350(2)(b) points to an ANSI power-transmission code; this talk does not describe it. "Test the guard with the saw unplugged," "wait for the blade to stop," "check the blade is rated for the saw" and "tag it and get it fixed" are good practice, not rule text; the rule is the maker's recommended speed.