R Safety Hub R Safety Hub Your prescription for a safer workplace

Eye and Face Protection

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Almost nobody loses an eye on a job they thought was dangerous. It is the small one. One cut, one grind, one nail, thirty seconds. And the glasses are on the dash of the truck, doing a fantastic job of protecting the dashboard.

You cannot put an eye back. That is the whole reason for this talk.

What the rule says

Eye and face protection is required wherever the work could injure eyes or face from physical, chemical or radiation hazards. That means flying particles, molten metal, liquid chemicals, acids and caustics, gases and vapors, harmful light like lasers, ultraviolet or infrared, and anything that can puncture.

The protection has to meet a standard the code names, ANSI Z87.1. That is a pointer in the Washington and federal rules themselves, so check your glasses, their packaging and the maker's paperwork for it. Gas-station sunglasses are not safety glasses unless they meet it.

Where there is a flying-object hazard, the protection needs side protection, such as safety glasses with side shields, or wraparounds. Front-only lenses leave the sides open, and grinding debris does not politely arrive from straight ahead.

If you wear prescription glasses, the eye protection must either have your prescription built in, or be big enough to go over your glasses without disturbing them. Your everyday glasses are not safety glasses.

Who pays

In Washington, protective equipment used to meet these rules must be provided by the employer at no cost to you. There are narrow exceptions. One is non-specialty prescription safety eyewear, if the employer lets you wear it off the job. Another is replacement gear when you lost it or damaged it on purpose.

Matching the protection to the job

Washington requires employers to look for hazards and decide what protective gear is needed, and to put a written certification of that assessment on file. That is where the answers come from.

The code has its own guide table. Goggles for dust, chips and splash. Safety glasses with side shields for general work with flying particles. A face shield for grinding, cutting and chemical splash, and for severe exposure the table has the face shield worn over goggles, not by itself. Welding needs a welding helmet or the right shaded lens for the process.

Know your spot

Before work starts, know where the first aid kit and the eyewash are for this job, and tell your supervisor about any eye injury, even a small one. When in doubt, have it checked out.

Talk it over

  1. Pick up your glasses right now. Do they have side protection, and do you know they meet the standard?
  2. When you grind, where is your face protection, and what is under it?

Before you go

Rated glasses, side protection, a shield over goggles for the heavy stuff, and the employer pays.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-155-215(1)(a), (b) and (c); WAC 296-800-16050 (hazards, side protection, prescription lenses, ANSI Z87.1 pointer); WAC 296-800-16005 and 16010 (hazard assessment, written certification); WAC 296-155-200(6) (employer pays). Federal: 29 CFR 1926.102(a) and (b)(1); 29 CFR 1926.95(d)(1). Table C-1 in WAC 296-155-215 is the selection guide. The ANSI Z87.1 standard is copyrighted: the code points to it, and this talk does not quote or explain it.