R Safety Hub R Safety Hub Your prescription for a safer workplace

Forklift Safety

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Today is about forklifts. Whether you drive one or just walk past one fifty times a day, this talk is for you.

A forklift is not a car. It carries heavy weight up front, and the load can block the driver's view. That's why there's a whole rule just for them.

Who can drive

Only people who have finished forklift training. That's classroom, hands-on practice, and a check ride where somebody qualified watches you drive. A trainee can drive only with a qualified trainer right there supervising.

Your driving gets evaluated again at least every three years. And you get a refresher if you have an accident or a near miss, if somebody sees you driving unsafe, or if you switch to a different kind of truck.

"I drove one at my cousin's place" is not training.

Check it every day

The truck gets inspected every day before it's used, following the maker's instructions. If something's wrong, report it and get it fixed. Don't just park it for the next person to find.

For everybody on foot

Never walk or stand under raised forks. Loaded or empty. Not for a second.

Keep your hands and arms out of the mast. And stay out of the truck's path.

No riding on the forks, and no riding unless there's a real, safe place to ride and you're allowed to.

If a forklift is coming, make eye contact with the driver before you cross. That's good practice, not a quote from the rule, but it works.

For drivers

Wear the seatbelt if the truck has one.

Follow the site speed limit. Stay about three truck lengths behind another truck. Look where you're going. Slow down and honk at corners, doorways and blind spots. Slow down on wet or muddy ground and in turns.

Never drive up to somebody standing in front of a wall, a bench or anything solid. And no horseplay. The rule actually says no stunt driving. Save it for the video games.

Carrying the load

Know your capacity. It's posted on the truck, and you don't go over it.

Get the forks all the way under the load, and tilt back to steady it. Carry it low, only as high as you need to clear the ground.

If the load blocks your view, drive backward with the load trailing.

On a steep slope, more than ten percent, keep the load pointed uphill. Going up, drive forward. Going down, back down.

Getting off

Every time you get off: forks all the way down, controls in neutral, brake set. If you're walking away, more than twenty-five feet or out of sight, also shut it off, and block the wheels if you're on a slope.

Lifting people

Never lift a person on the bare forks or a pallet. People go up only on a platform built for it, attached to the forks, with rails all the way around.

Talk it over

  1. Who on this job is trained and allowed to drive the forklift?
  2. Where on this site do people walk close to where the forklift works?

Before you go

Trained drivers only, nobody under the forks, load low, and look where you're going.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-863-60005, -60010, -60015 (training, refresher, evaluation every three years); -30010 (daily inspection); -40005 (seatbelts, nobody under raised forks, mast, riders, horseplay, bench rule); -40010 (driving); -40015 (loads, trailing load, upslope over ten percent); -40020 (leaving the truck; unattended means over twenty-five feet or out of sight); WAC 296-155-615(3) (construction: chapter 296-863 applies, posted capacity, riders, personnel platforms). Federal: 29 CFR 1926.602(d), 1910.178(l), (m), (n). "A forklift is not a car" follows the rule's training topic on differences from an automobile. Eye contact with the driver is good practice.