Morning, everybody. Today is about the tall steel bottles. Oxygen, acetylene, and the other fuel gases we use with a torch.
A full cylinder holds a lot of gas under pressure, and some of it burns. So most of these rules are about keeping that bottle standing, capped and closed.
Standing up and tied off
Washington's rule says compressed gas cylinders are secured upright at all times. Chained, strapped, or in a cart made for them. The only exception is the short time it's actually being lifted or carried.
When you move one, the regulator comes off and the cap goes on, unless it's on a cart built for it. Roll it on its bottom edge. Don't drop it, don't let them bang together, and don't lift it by the cap.
When you're done, when it's empty, or any time it gets moved, the valve gets closed.
And if one is frozen to the ground, warm water. Not boiling. And no prying with a bar under the valve.
Oxygen and fuel stay apart
In storage, oxygen and fuel gas don't share a corner. The rule says twenty feet apart, or a fire-rated wall at least five feet high between them. Oxygen also stays away from oil and grease. No oily gloves on the fittings. Never point oxygen at your clothes or at anything oily.
Where cylinders go during the work
Far enough from the cutting that sparks and slag can't reach them, or behind a shield. Not anywhere they can become part of an electric circuit. And never strike an arc on a cylinder.
Here's a big one. Oxygen and fuel gas cylinders never go into a confined space. The bottles stay outside. And when the torch is inside an enclosed space and you walk away from it, even for lunch, the gas gets shut off outside.
Check before you light
The rule says the hose and the torch both get looked at at the start of every shift. Leaking valves, bad couplings, cracked or burned hose. Bad hose comes out of service. Keep hoses off walkways, ladders and stairs.
Before you put the regulator on, crack the valve for a second to blow out dirt. Stand off to the side, not in front of it. Open valves slowly. Fuel gas, no more than a turn and a half, so you can shut it fast.
And light it with a striker. Not a match. And not off somebody else's hot work. Your cigarette lighter in your shirt pocket near a torch is a whole other talk.
Fire rules for hot work
Before you cut or weld, move the work to a safe place, or move whatever can burn away from the work. If neither can happen, shield it.
A fire extinguisher is right there, ready to use. Not in the truck. Right there.
When normal precautions aren't enough, somebody is assigned as a fire watch. They watch during the work, and they stay long enough after to be sure there's no fire. Sparks love to sit and smolder.
Work on a wall or floor? Somebody checks the other side too. Heat and sparks go through.
And never cut or heat a drum or tank that held something flammable until it's been cleaned and tested, or filled with water, and vented. An empty drum is not empty. It's full of vapor.
Talk it over
- Walk past our cylinders in your head. Is every one chained upright, and are oxygen and fuel stored apart?
- On our last hot-work job, who was the fire watch, and how long did they stay after?
Before you go
Bottles upright, capped and closed. Oxygen and fuel apart. Check the hose and torch every shift. Extinguisher right there, and someone watching for fire after.