R Safety Hub R Safety Hub Your prescription for a safer workplace

Harness Inspection

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Quick one today, and it is about the harness.

Here is a harness that has been riding in the back of a truck since spring. It buckles fine. Clicks nice. So it's good, right?

Not so fast. A working buckle tells us the buckle works. It tells us nothing about the webbing, and the webbing is the part that catches you.

What the rule says

Before every use, the harness, the lanyard and the hardware all get looked over. Every time. Not once a week, and not only when it looks rough. The check is for mildew, wear, damage and other deterioration, and it follows the maker's instructions. If something's function or strength has been hurt, it comes out of service.

What to look for

Run the webbing through your hands, a foot at a time, bending it into an upside-down U as you go. That opens up the fibers so you can see into them. This is a common way to do it, so check your maker's instructions too.

On the webbing, look for cuts, nicks and tears, broken fibers, fraying, and hard or shiny spots. Here's the one that surprises people: shiny is bad. We all grew up thinking shiny means clean. On webbing, shiny can mean heat or chemical damage. Not our friend.

On the stitching, look for pulled, missing or cut stitches.

On the hardware, look for bends, twists, rough or sharp edges, rust, and anything somebody modified on their own.

And the lanyard and connectors get the same look. A perfect harness on a damaged lanyard is still a damaged system.

If you find something

It comes out of service, right then. Tag it, pull it, get another. Not at the end of the shift.

Don't stitch it, tape it or patch it yourself. Follow the maker's instructions, and if they don't cover a repair, don't invent one.

And if you're not sure, it's out. "Probably fine" is not an inspection result. Ask your supervisor.

Somebody always says, "It's just a little nick, and we're behind." Fair enough. You'll be behind schedule with a harness that works.

Keeping it healthy

Wipe off dirt with a damp sponge, with mild soap and water if it needs it. Hang it to dry, away from heat and direct sun. Store it clean and dry, away from chemicals. A harness that spent the summer in a sunny truck bed has been aging the whole time, whether you can see it or not.

Talk it over

  1. When did you last run your webbing through your hands, instead of just glancing at it?
  2. Where does your harness live between jobs, and what is it sitting next to?

Before you go

Before it goes on, it gets looked at. Every time, every person.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-880-10005(2)(a), inspect all components before each use per manufacturer's specifications; remove defective components from service. Federal: 29 CFR 1926.502(d)(21). The ANSI/ASSP Z359 standards are voluntary and copyrighted; this talk does not quote them. Your maker's instructions are what the rule points to.