R Safety Hub R Safety Hub Your prescription for a safer workplace

Laser Levels and Lasers on the Job

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Today is about lasers: the rotating laser for grade, the line laser for layout, the dot laser for plumb. Great tools. But the stronger classes can hurt your eyes.

Who runs it

Washington's construction rule says only qualified and trained people install, adjust and operate laser equipment. The operator carries proof of that qualification on them the whole time. If you have never been shown how to run the laser, you are not the one setting it up. Ask. That's the rule.

Everybody who may be exposed to the beam also gets laser safety training on the hazards and controls for the laser in use. If you work around the laser and nobody has gone over it with you, say so.

Read the label

Every laser has a label showing its hazard class. Look at it. The rule only allows Class one, two and three lasers on a construction job. Class four is not allowed at all.

Where Class two or three lasers are in use, the area is posted with standard laser warning signs. If you see those signs, there's a beam around. Keep your eyes open, and out of the beam.

The beam

The beam is never pointed at a person. Not as a joke, not to get attention. Nobody here is a cat.

When possible, the laser is set above people's heads, so the beam runs over everybody, not across their eyes.

When the beam isn't needed, it gets a shutter or a cap, or it gets turned off. When the laser is left alone for a good while, like lunch, overnight or shift change, it gets turned off.

And never look into the beam to line it up. The rule says alignment is guided by a mechanical or electronic detector. "Don't use your eye" is our own warning, not the rule's words. Your eye is not a detector.

Weather

In rain, snow, dust or fog, if it's not practical to shut the laser down, keep people out of range of the laser and the target.

Eye protection

Where there could be a hazardous exposure to the beam, direct or reflected, the company provides anti-laser eye protection at no cost to you. It's made for that laser's kind of light. You wear it whenever that exposure could happen. Regular safety glasses are not laser glasses. If you think you need them and don't have them, ask.

If somebody does take a beam in the eye, tell your supervisor right away and get it looked at. When in doubt, have it checked out. Don't rub it and hope.

Talk it over

  1. Who on this crew is trained to set up our laser, and do they have proof of it on them?
  2. Where does our laser sit at lunch, and is it still running?

Before you go

Read the label. Never at a person. Off when you walk away. Detector, not eyeballs.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-155-155(1) (only qualified and trained employees install, adjust and operate laser equipment), (2) (proof of qualification in the operator's possession at all times), (3) (antilaser eye protection where a potentially hazardous exposure to direct or reflected laser radiation exists, see WAC 296-62-09005(4)), (4) (areas where Class II and III lasers are used posted with standard laser warning placards), (5) (beam shutters or caps, or laser off, when transmission not required; off when left unattended for a substantial period, such as lunch, overnight or change of shifts), (6) (only mechanical or electronic means as a detector for guiding internal alignment), (7) (beam not directed at employees), (8) (rain, snow, dust or fog: keep employees out of range of source and target when it is impracticable to stop), (9) (label showing hazard classification), (10) (only Class I, II or III; no Class IV), (11) (set above the heads of employees when possible). Federal: 29 CFR 1926.54(a) to (l). Differences seen: federal eye protection trigger is exposure over 5 milliwatts; federal (h) prohibits operation in rain, snow, dust or fog where practicable; federal label shows maximum output; the Class IV ban was seen only in the Washington text. "Never look into the beam to line it up" is our plain reading of (6), which is about guiding the laser's internal alignment. "Not a cat" is a joke, not about an injury. WAC 296-62-09005(4)(d), (d)(i), (f): protective equipment at no cost, worn whenever a potentially hazardous exposure may result; eyewear designed for the wavelength and radiant energy of the laser; all employees who may be exposed receive laser safety training (the eyewear limit points to an ANSI standard; not described).