Morning, everybody. Today's tool is the one that fires a pin into concrete or steel with a small explosive load. Some people call it a powder-actuated tool. Some call it a shot gun, a stud gun, or a few other names I won't repeat. Whatever we call it, it works like a firearm, and it gets treated like one.
Who can use it
Not everybody. Washington's rule says only a qualified operator runs one of these.
Qualified means real training, from an authorized instructor. You learn to read the manual, clean the tool, spot worn parts, and know the color code on the loads. You show the instructor you can use it. Then you pass the maker's written test. And you get a card.
Here's the part people forget. You carry that card while you're using the tool. On you. Not in the glove box of a truck in another county.
Federal OSHA says the same idea: only people trained on that particular tool can use it.
Before you fire it
Look the tool over every day, before you use it, the way the maker says to. If something's wrong, it gets tagged "defective" and comes out of service until it's fixed the maker's way.
Use the lowest power that will set the fastener. More bang is not better. More bang means the pin goes places you didn't plan.
Eye or face protection for the operator, for whoever's helping, and for anybody close by. And hearing protection when you're shooting in a tight, closed-in space.
While you're using it
Don't load it until you're ready to fire. If you get interrupted, unload it. Right then.
Never point it at anybody. Loaded or empty. Keep your hands away from the business end.
Hold it square to the surface, straight on, unless the maker says otherwise for that job.
And if it misfires, don't lift it up to look down the barrel. Hold it firm against the surface for thirty seconds. Then follow the maker's instructions. Thirty seconds feels like a long time. Count it anyway.
What not to shoot into
Stay out of very hard or brittle stuff: cast iron, glazed tile, hardened steel, glass block, natural rock, hollow tile and most brick. Those can shatter, or the pin can bounce.
Thin or soft material only if something is behind it to stop the pin going all the way through. Somebody could be on the other side of that wall.
Stay back from edges. Half an inch from the edge of steel. Three inches from the edge of masonry. Not into cracked or broken-out concrete. Not into concrete that's too thin. Not through an old hole, unless you have the maker's guide for it.
If you're not sure about the material, the rule's own test is to use a fastener as a center punch first and see what happens.
When you're done
It goes back in its locked box with its loads, the power levels kept separate. Never left lying around where somebody untrained could pick it up. And where these tools are in use, a sign is posted saying so.
A loaded tool on a bucket at lunch is how a bad day starts. Locked box. Every time.
Talk it over
- Who on this crew has a current operator's card, and is it on you right now?
- And where do our tools and loads live overnight, and who has the key?
Before you go
Trained and carded. Lowest load that works. Never point it. Thirty seconds on a misfire. Locked up when you're done.