R Safety Hub R Safety Hub Your prescription for a safer workplace

Securing Cargo on a Work Truck or Trailer

Lines in italics are for the reader, not the crew. If you can, hold up one of the straps from a truck while you read. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Today is about tying down a load. It's for anyone who drives a work truck or pulls a trailer, and anyone who helps load one.

Remember one thing. Whatever comes off your truck lands in front of whoever is driving behind you.

Washington law says any vehicle on a public road, a pickup included, has its load fastened so it can't come loose. Bigger work trucks and trailers also fall under the federal truck rules, and that's where today's details come from. On a smaller truck, treat them as good practice.

Look at your straps

The federal rule says every strap, chain and binder has to be in working order. No cuts, no cracks. And no knots in a tiedown, ever.

Where the load could rub or cut a strap, use edge protection. A sharp corner works on a strap like a saw.

If a strap is worn out, or the truck is short on edge protectors, tell your supervisor so it gets replaced.

Tie it down

Anything that can roll, like pipe, gets chocked, wedged or cradled so it can't.

If nothing up front keeps the load from sliding forward, the rule says anything over five feet long, or anything short that weighs over eleven hundred pounds, gets at least two tiedowns, and long loads get more. Not sure how many? Ask before you roll.

Walk around it

Before you drive, take one lap around the truck. Load tied down. Tailgate, doors and tarps secured. Nothing blocking your view.

Check it again

A load that looked tight in the yard can settle once it has bounced down the road. So the rule says the driver checks the load and the tiedowns within the first fifty miles. After that, check again whenever your duty status changes, or every three hours, or every hundred and fifty miles, whichever comes first. Tighten it, or add a tiedown, if it needs it.

Somebody always says, "It's heavy. It's not going anywhere." Heavy is exactly why it gets tied down. When the truck stops short, heavy wants to keep going.

Talk it over

  1. You pick up a strap and find a cut in it. What happens to that strap?
  2. What would make it easier for us to tie down every load right, even when we're in a hurry to get out of the yard?

Before you go

Good straps, no knots, enough tiedowns, one lap around the truck, and check it again in the first fifty miles.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Rules behind the spoken lines. Washington: RCW 46.61.655(2) (no person may operate any vehicle with any load on a public highway unless the load is securely fastened to prevent it from becoming loose, detached or a hazard to other users of the highway; this is the "any vehicle, a pickup included" line, and "pickup" is our example of "any vehicle"); WAC 446-65-010(1)(q), (s), (t) (the State Patrol adopts 49 CFR parts 390, 392 and 393 as they exist on April 25, 2026, for motor carriers in intrastate or interstate commerce). Federal: 49 CFR 393.100(a) to (c) (applies to trucks, truck tractors, semitrailers, full trailers and pole trailers; cargo secured so it does not leak, spill, blow or fall, or shift enough to hurt stability or handling); 393.104(b) (tiedowns and parts in proper working order, no damaged or weakened components such as cracks or cuts), (f)(1) (no knots), (f)(4) (edge protection wherever a tiedown would be subject to abrasion or cutting where it touches the cargo); 393.106(c)(1) (articles likely to roll restrained by chocks, wedges, a cradle or equivalent that cannot come loose in transit); 393.110(b)(2)(ii), (3) (not blocked against forward movement: two tiedowns for an article longer than 5 feet up to 10 feet, whatever the weight; two plus one for every further 10 feet or part of it); 392.9(a)(1) to (3) (cargo properly distributed and adequately secured; tailgate, tailboard, doors, tarpaulins, spare tire and other equipment secured; view ahead and to the sides not obscured), (b)(1) (the driver assures this before driving), (b)(2) (inspect the cargo and securing devices within the first 50 miles and adjust or add devices as needed), (b)(3) (re-examine and adjust at a change of duty status, after 3 hours of driving, or after 150 miles, whichever occurs first).