R Safety Hub R Safety Hub Your prescription for a safer workplace

Working From a Ladder

Lines in italics are for the reader, not the crew. How to read a talk

Printable version with sign-in sheet (PDF)

Read this out loud

Morning, everybody. Today is about the part after you climb. You're up there, and now you're working. Drilling, caulking, hanging, painting.

Working from a ladder has its own rules.

Tie it off top and bottom

Washington's rule says when you are working from a ladder, it gets secured at the top and the bottom. Not just footed by a buddy for a minute. Tied, strapped or clamped so it can't kick out at the bottom or slide sideways at the top.

And nobody moves, shifts or adjusts a ladder while someone is on it. Not even a little scoot. You come down, then it moves.

Traffic and doors

If the ladder is set where work or traffic could knock it, like a walkway, a driveway or near a forklift, it gets secured or barricaded so the traffic stays away from it. If it's in front of a door that swings toward it, block the door open, lock it, or guard it.

Keep the area at the top and bottom of the ladder clear.

The twenty-five-foot rule

Here's one most people have never heard. If the job needs both of your hands, and you're more than twenty-five feet above the ground or floor, the rule says you wear a safety belt with a lanyard secured to the ladder. The rule's words are 'safety belt,' but Washington's fall protection rules today call for a full body harness or a positioning harness for this kind of work, not a waist-only belt. Ask your supervisor what gear the company uses for it.

And above twenty-five feet, if the work needs eye protection or a respirator, it is not done from a ladder at all. Think grinding, chipping, spraying. Plan that work for a lift or a scaffold instead. That part is our advice; the rule just says not from the ladder.

Reaching and loads

Don't carry anything up or down that could throw off your balance. Keep at least one hand on the ladder going up and coming down, and face it. And keep the rungs free of oil, grease, caulk, paint and anything slick.

Don't overload it. Every ladder has a maximum load and a maker's rating, and that counts you, your tools and your materials. That bucket of mud counts.

When you reach, keep your belt buckle between the rails. If you have to stretch, come down and move the ladder. That is good practice, not the rule's words.

Somebody always says, "It's one more screw." Sure. And the ground is one more step down than you planned.

A ladder is not a scaffold

A ladder is not a work platform, a scaffold plank, a brace or a lever, unless the maker says it's built for that. The rule lists a few more; those are the common ones.

Talk it over

  1. When we work from a ladder on this job, how do we tie off the top?
  2. What work have we done above twenty-five feet off a ladder that should have been on a lift?

Before you go

Secured top and bottom, nobody moves it with you on it, both hands above twenty-five feet means tied in, and grinding or spraying up there means a lift.

Short on time, or no one to lead it? Doc and Red can run this talk for you in the R Safety Hub app.

Get started

Reference (not read aloud). Washington: WAC 296-876-40040(1) to (4) (not moved, shifted or adjusted while anyone is on it; secured at top and bottom when working from it; safety belt with a lanyard secured to the ladder for work requiring both hands from a ladder more than twenty-five feet above the ground or floor; work requiring eye protection or a respirator prohibited from a ladder more than twenty-five feet up); 296-876-40010(1), (2) (secured or barricaded where activities or traffic could displace it; door opening toward it blocked open, locked or guarded); 296-876-40025(1), (2), (4), (6) (one hand, face the ladder, top and bottom area clear, no load causing loss of balance); 296-876-40005(1) and note, (2) (intended purpose; unless the maker recommends it, not a brace, skid, lever, guy or gin pole, gangway, platform, scaffold plank or material hoist; maximum intended load and rated capacity). Federal: 29 CFR 1926.1053(b)(6), (7), (8) (stable surfaces or secured; secured or barricaded against displacement by activities or traffic), (b)(11) (not moved, shifted or extended while occupied), (b)(20) to (22). The secure-top-and-bottom and twenty-five-foot rules are Washington rules; no matching federal sentence was found in 1926.1053. "Tied, strapped or clamped," "not just footed by a buddy," the examples of traffic, of eye-protection and respirator work (grinding, chipping, spraying) and of what counts toward the load, the belt buckle habit, "come down and move the ladder," and "ask whether a lift or scaffold is the better tool" are plain explanation or good practice, not rule text. "Safety belt" is the rule's own wording; the talk tells the crew to ask what gear the company uses.